Information videos on how the patient should hook up using the Nox T3 device can be found here:Īfter a night of recording the device needs to be connected to the computer and downloaded. Dependent on if you have configured for a manual recording or a scheduled recording, see instructions here: Then click Next>īefore the devices are sent home to the patients the Nox T3 device needs to be paired with the Nonin oximeter. Also, select the duration time for the recording. Here you select, if it's a manually started recording or a automatic scheduled recording. To create a custom Recording type follow the instructions here.Īlso, type in the applicable oximeter PIN address, then click Next > The sensor setup chosen in the recording type is displayed on the man on the image. The recording types define what channel configuration is used on the device (what device profile) and what auxiliary devices are used in the recording. The recording types available are the built-in ones from the software. Select a Recording type from the drop-down list. The Nox T3 device should be displayed on the recording page showing the devices status, firmware and serial number.Ī Nox T3 Configuration Wizard will appear. If the device is not detected try re-connecting the device. Noxturnal automatically detects the device within 2-4 seconds. Connect the device to a computer with the USB cable. To open the battery lid, press with the lid key (accompanying the system) and slide the battery lid down, towards the bottom of the device. The USB connector is placed under the battery lid. To connect the Nox T3 device to a computer you need to access the USB connector on the device. When you have finished the install, you can start Noxturnal and connect the Nox T3 device with a USB cable to the computer. Run the software after installing the software.
Note that you have to have administrator privilege on your computer in order to install the software. Instructions on how to install the software and system requirements can be found here, in the Noxturnal software Manual. Before installing the software, review the system requirements for running the application. Start by installing the Noxturnal software. The following article is a quick set up guide and here you will find references to the relative material for the Nox T3 and Noxturnal. Learn how to set up the Nox T3 and the Noxturnal 5 software for T3 studies.
0 kommentar(er)
